Jump to content

Supercritical water reactor

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Spyglasses (talk | contribs) at 01:56, 3 May 2022 (→Introduction: Discard unneeded word). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Supercritical water reactor scheme.

The supercritical water reactor (SCWR) is a concept Generation IV reactor,[1] designed as a light water reactor (LWR) that operates at supercritical pressure (i.e. greater than 22.1 MPa). The term critical in this context refers to the critical point of water, and must not be confused with the concept of criticality of the nuclear reactor.

The water heated in the reactor core becomes a supercritical fluid above the critical temperature of 374 °C, transitioning from a fluid more resembling liquid water to a fluid more resembling saturated steam (which can be used in a steam turbine), without going through the distinct phase transition of boiling.

In contrast, the well-established pressurized water reactors (PWR) have a primary cooling loop of liquid water at a subcritical pressure, transporting heat from the reactor core to a secondary cooling loop, where the steam for driving the turbines is produced in a boiler (called the steam generator). Boiling water reactors (BWR) operate at even lower pressures, with the boiling process to generate the steam happening in the reactor core.

The supercritical steam generator is a proven technology. The development of SCWR systems is considered a promising advancement for nuclear power plants because of its high thermal efficiency (~45 % vs. ~33 % for current LWRs) and simpler design. As of 2012 the concept was being investigated by 32 organizations in 13 countries.[2]

History

The super-heated steam cooled reactors operating at subcritical-pressure were experimented with in both Soviet Union and in the United States as early as the 1950s and 1960s such as Beloyarsk Nuclear Power Station, Pathfinder and Bonus of GE's Operation Sunrise program. These are not SCWRs. SCWRs were developed from the 1990s onwards.[3] Both a LWR-type SCWR with a reactor pressure vessel and a CANDU-type SCWR with pressure tubes are being developed.

A 2010 book includes conceptual design and analysis methods such as core design, plant system, plant dynamics and control, plant startup and stability, safety, fast reactor design etc.[4]

A 2013 document saw the completion of a prototypical fueled loop test in 2015.[5] A Fuel Qualification Test was completed in 2014.[6]

A 2014 book saw reactor conceptual design of a thermal spectrum reactor (Super LWR) and a fast reactor (Super FR) and experimental results of thermal hydraulics, materials and material-coolant interactions.[7]

Design

Moderator-coolant

The SCWR operates at supercritical pressure. The reactor outlet coolant is supercritical water. Light water is used as a neutron moderator and coolant. Above the critical point, steam and liquid become the same density and are indistinguishable, eliminating the need for pressurizers and steam generators (PWR), or jet/recirculation pumps, steam separators and dryers (BWR). Also by avoiding boiling, SCWR does not generate chaotic voids (bubbles) with less density and moderating effect. In a LWR this can affect heat transfer and water flow, and the feedback can make the reactor power harder to predict and control. Neutronic and thermal hydraulic coupled calculation is needed to predict the power distribution. SCWR's simplification should reduce construction costs and improve reliability and safety. A LWR type SCWR adopts water rods with thermal insulation and A CANDU type SCWR keeps water moderator in a Calandria tank. A fast reactor core of the LWR type SCWR adopts tight fuel rod lattice as a high conversion LWR. The fast neutron spectrum SCWR has advantages of a higher power density, but needs plutonium and uranium mixed oxides fuel which will be available from reprocessing.　

Control

SCWRs would likely have control rods inserted through the top, as is done in PWRs.

Material

The conditions inside an SCWR are harsher than those in LWRs, LMFBRs, and supercritical fossil fuel plants (with which much experience has been gained, though this does not include the combination of harsh environment and intense neutron radiation). SCWRs need a higher standard of core materials (especially fuel cladding) than either of these. R&D focuses on:

  • The chemistry of supercritical water under radiation (preventing stress corrosion cracking, and maintaining corrosion resistance under neutron radiation and high temperatures)
  • Dimensional and microstructural stability (preventing embrittlement, retaining strength and creep resistance also under radiation and high temperatures)
  • Materials that both resist the harsh conditions and do not absorb too many neutrons, which affects fuel economy

Advantages

  • Supercritical water has excellent heat transfer properties allowing a high power density, a small core, and a small containment structure.
  • The use of a supercritical Rankine cycle with its typically higher temperatures improves efficiency (would be ~45 % versus ~33 % of current PWR/BWRs).
  • This higher efficiency would lead to better fuel economy and a lighter fuel load, lessening residual (decay) heat.
  • SCWR is typically designed as a direct-cycle, whereby steam or hot supercritical water from the core is used directly in a steam turbine. This makes the design simple. As a BWR is simpler than a PWR, a SCWR is a lot simpler and more compact than a less-efficient BWR having the same electrical output. There are no steam separators, steam dryers, internal recirculation pumps, or recirculation flow inside the pressure vessel. The design is a once-through, direct-cycle, the simplest type of cycle possible. The stored thermal and radiologic energy in the smaller core and its (primary) cooling circuit would also be less than that of either a BWR's or a PWR's.[8]
  • Water is liquid at room temperature, cheap, non-toxic and transparent, simplifying inspection and repair (compared to liquid metal cooled reactors).
  • A fast SCWR could be a breeder reactor, like the proposed Clean And Environmentally Safe Advanced Reactor, and could burn the long-lived actinide isotopes.
  • A heavy-water SCWR could breed fuel from thorium (4x more abundant than uranium). Similar to a CANDU it could also use unenriched natural uranium if enough moderation is provided
  • Process heat can be delivered at higher temperatures than other water cooled reactors allow

Disadvantages

  • Lower water inventory (due to compact primary loop) means less heat capacity to buffer transients and accidents (e.g. loss of feedwater flow or large break loss-of-coolant accident) resulting in accident and transient temperatures that are too high for conventional metallic cladding.[9]

However, Safety analysis of LWR type SCWR showed that safety criteria are met at accidents and abnormal transients including total loss of flow and loss of coolant accident.[9]: 97, 104  No double ended break occurs because of the once-through coolant cycle. Core is cooled by the induced flow at the loss of coolant accident.

  • Higher pressure combined with higher temperature and also a higher temperature rise across the core (compared to PWR/BWRs) result in increased mechanical and thermal stresses on vessel materials that are difficult to solve. A LWR type design, reactor pressure vessel inner wall is cooled by the inlet coolant as a PWR. Outlet coolant nozzles are equipped with thermal sleeves. A pressure-tube design, where the core is divided up into smaller tubes for each fuel channel, has potentially fewer issues here, as smaller diameter tubing can be much thinner than massive single pressure vessels, and the tube can be insulated on the inside with inert ceramic insulation so it can operate at low (calandria water) temperature.[10]

The coolant greatly reduces its density at the end of the core, resulting in a need to place extra moderator there. A LWR type SCWR design adopts water rods in the fuel assemblies. Most designs of CANDU type SCWR use an internal calandria where part of the feedwater flow is guided through top tubes through the core, that provide the added moderation (feedwater) in that region. This has the added advantage of being able to cool the entire vessel wall with feedwater, but results in a complex and materially demanding (high temperature, high temperature differences, high radiation) internal calandria and plena arrangement. Again a pressure-tube design has potentially fewer issues, as most of the moderator is in the calandria at low temperature and pressure, reducing the coolant density effect on moderation, and the actual pressure tube can be kept cool by the calandria water.[10]

  • Extensive material development and research on supercritical water chemistry under radiation is needed
  • Special start-up procedures needed to avoid instability before the water reaches supercritical conditions. Instability is managed by power to coolant flow rate ratio as a BWR.
  • A fast SCWR needs a relatively complex reactor core to have a negative void coefficient. But single coolant flow pass core is feasible.
  • As with all alternatives to currently widespread designs (mostly subcritical water cooled, water moderated thermal reactors of some kind) there will be fewer suppliers of technology and parts and less expertise at least initially than for decades old proven technology or its evolutionary improvements such as generation III+ reactors
  • The chemical shim might behave drastically different as the solution properties of supercritical water are vastly different from those of liquid water. Currently most pressurized water reactors employ boric acid to control reactivity early in burnup
  • Depending on design online refueling may be impossible. While CANDUs are capable of online refueling, other water moderated reactors are not.

See also

References

  1. ^ https://www.gen-4.org/gif/jcms/c_40679/technology-system-scwr |accessdate=7 Apr 2016
  2. ^ Buongiorno, Jacopo (July 2004), "The Supercritical Water Cooled Reactor: Ongoing Research and Development in the U.S", 2004 international congress on advances in nuclear power plants, American Nuclear Society - ANS, La Grange Park (United States), OSTI 21160713
  3. ^ Oka, Yoshiaki; Koshizuka, Seiichi (2001), "Supercritical-pressure, Once-through Cycle Light Water Cooled Reactor Concept", Nuclear Science and Technology, 38 (12): 1081–1089, doi:10.1080/18811248.2001.9715139
  4. ^ Oka, Yoshiaki; Koshizuka, Seiichi; Ishiwatari, Yuki; Yamaji, Akifumi (2010). Super Light Water Rectors and Super Fast Reactors. Springer. ISBN 978-1-4419-6034-4.
  5. ^ https://www.gen-4.org/gif/upload/docs/application/pdf/2013-09/gif_rd_outlook_for_generation_iv_nuclear_energy_systems.pdf [bare URL PDF]
  6. ^ "European Commission : CORDIS : Projects and Results : Final Report Summary - SCWR-FQT (Supercritical Water Reactor - Fuel Qualification Test)". cordis.europa.eu. Retrieved 21 April 2018.
  7. ^ Yoshiaki Oka; Hideo Mori, eds. (2014). Supercritical-Pressure Light Water Cooled Reactors. Springer. ISBN 978-4-431-55024-2.
  8. ^ Tsiklauri, Georgi; Talbert, Robert; Schmitt, Bruce; Filippov, Gennady; Bogoyavlensky, Roald; Grishanin, Evgenei (2005). "Supercritical steam cycle for nuclear power plant" (PDF). Nuclear Engineering and Design. 235 (15): 1651–1664. doi:10.1016/j.nucengdes.2004.11.016. ISSN 0029-5493. Archived from the original (PDF) on 2013-09-28. Retrieved 2013-09-25.
  9. ^ a b MacDonald, Philip; Buongiorno, Jacopo; Davis, Cliff; Witt, Robert (2003), Feasibility Study of Supercritical Light Water Cooled Reactors for Electric Power Production - Progress Report for Work Through September 2003 - 2nd Annual Report and 8th Quarterly Report (PDF), Idaho National Laboratory
  10. ^ a b Chow, Chun K.; Khartabil, Hussam F. (2007), "Conceptual fuel channel designs for CANDU-SCWR" (PDF), Nuclear Engineering and Technology, 40 (2), archived from the original (PDF) on 2013-09-27
Wikimedia Commons has media related to Supercritical water reactors.
Retrieved from "https://en.wikipedia.org/w/index.php?title=Supercritical_water_reactor&oldid=1085902653"