Venera 10

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by 144.167.113.34 (talk) at 16:41, 21 September 2018 (Add a mission_duration figure for launch to last contact.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Venera 10
Venera 10
Mission typeVenus orbiter / lander
OperatorLavochkin
COSPAR ID1975-054A
1975-054D
SATCAT no.7947
8423
Mission durationTravel: 4 months and 9 days
Orbiter: 144 days
Lander: 65 minutes
Last contact: 286 days
Spacecraft properties
Spacecraft type4V-1 No. 661
ManufacturerLavochkin
Launch mass5,033 kg (11,096 lb)
BOL mass2,230 kg (4,920 lb)
Landing mass1,560 kg (3,440 lb)
Dimensions2.7 m × 2.3 m × 5.7 m (8.9 ft × 7.5 ft × 18.7 ft)
Start of mission
Launch dateJune 14, 1975 (1975-06-14), 03:00:31 UTC
RocketProton with upper and escape stages
Launch siteBaikonur 81/24
End of mission
Last contactMarch 26, 1976 (March 26, 1976)
Orbital parameters
Reference systemCytherocentric
Eccentricity0.8798
Pericytherion altitude1,620 kilometers (1,010 mi)
Apocytherion altitude113,900 kilometers (70,800 mi)
Inclination29.5°
Period49.4 hours
Revolution no.71
Venus orbiter
Orbital insertionOctober 23, 1975
Venus lander
Spacecraft componentVenera 10 descent craft
Landing date02:17, October 25, 1975
Landing site15°25′N 291°31′E / 15.42°N 291.51°E / 15.42; 291.51
(near Beta Regio)
 

Venera 10 (Russian: Венера-10 meaning Venus 10), or 4V-1 No. 661,[1] was a Soviet unmanned space mission to Venus. It consisted of an orbiter and a lander. It was launched on June 14, 1975 03:00:31 UTC and had a mass of 5033 kg (11096 lb).[2]

Orbiter

The orbiter entered Venus orbit on October 23, 1975. Its mission was to serve as a communications relay for the lander and to explore cloud layers and atmospheric parameters with several instruments and experiments:[3]

  • 1.6-2.8 μm IR Spectrometer
  • 8-28 μm IR Radiometer
  • 352 nm UV Photometer
  • 2 Photopolarimeters (335-800 nm)
  • 300-800 nm Spectrometer
  • Lyman-α H/D Spectrometer
  • Bistatic radar mapping
  • CM, DM radio occultations
  • Triaxial Magnetometer
  • 345-380 nm UV Camera
  • 355-445 nm Camera
  • 6 Electrostatic analyzers
  • 2 Modulation Ion Traps
  • Low-Energy Proton / Alpha detector
  • Low-Energy Electron detector
  • 3 Semiconductor counters
  • 2 Gas-Discharge counters
  • Cherenkov detector

The orbiter consisted of a cylinder with two solar panel wings and a high gain parabolic antenna attached to the curved surface. A bell-shaped unit holding propulsion systems was attached to the bottom of the cylinder, and mounted on top was a 2.4 meter sphere which held the landers. To reach Venus, the spacecraft traveled in a heliocentric orbit from Earth to the planet with perihelion of 0.72 AU, apohelion of 1.02 AU, eccentricity of 0.17, inclination of 2.3 degrees and orbital period of 294 days.

Lander

On October 23, 1975, this spacecraft was separated from the Orbiter, and landing was made with the sun near zenith, at 0517 UT, on October 25. A system of circulating fluid was used to distribute the heat load. This system, plus precooling prior to entry, permitted operation of the spacecraft for 65 min after landing. During descent, heat dissipation and deceleration were accomplished sequentially by protective hemispheric shells, three parachutes, a disk-shaped drag brake, and a compressible, metal, doughnut-shaped, landing cushion.[3]

Landing area of Venera 10 as mapped by the Magellan orbiter

It landed near the border area between Beta Regio and Hyndla Regio[4] (within a 150 km radius of 15°25′N 291°31′E / 15.42°N 291.51°E / 15.42; 291.51), three days after the touchdown of, and 2200 km from Venera 9.[5] Venera 10 measured a surface windspeed of 3.5 m/s. Other measurements included atmospheric pressure at various heights, and temperature, and surface light levels. Venera 10 was the second probe to send back black and white television pictures from the Venusian surface (after Venera 9). Venera 10 photographs showed lava rocks of pancake shape with lava or other weathered rocks in between. Planned 360 degree panoramic pictures could not be taken because, as with Venera 9, one of two camera lens covers failed to come off, limiting pictures to 180 degrees.

The lander communicated with Earth using the Venera 10 orbiter as a communication relay.[2]

Lander Payload:[3]

See also

References

  1. ^ Zak, Anatoly. "Venera-9 and 10". Russianspaceweb.com. Retrieved 14 April 2013.
  2. ^ a b "NSSDC Master Catalog - Venera 10". NASA National Science Data Center. Retrieved 13 April 2013.
  3. ^ a b c Mitchell, Don P. "First Pictures of the Surface of Venus". Retrieved 13 April 2013.
  4. ^ Andrew LePage, Venera 9 and 10 to Venus, October 22, 2015 (accessed 19 February 2016)
  5. ^ Interplanetary Spacecraft
Retrieved from "https://en.wikipedia.org/w/index.php?title=Venera_10&oldid=860577900"