Jump to content

VAXBI bus

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Векочел (talk | contribs) at 23:25, 5 November 2023 (De-link common terms (by script) per MOS:OVERLINK). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

VAXBI bus
VAX Bus Interconnect bus
Year created~1986; 38 years ago (1986)
Created byDigital Equipment Corporation
Width in bits32
VAX ECC memory card with VAXBI interface highlighted.

The VAXBI bus (VAX Bus Interconnect bus) is a computer bus designed and sold by the Digital Equipment Corporation (DEC) of Maynard, Massachusetts.[1]

VAX BI to Unibus adapter.

The bus is an advanced, configuration-free synchronous bus used on DEC's later VAX computers. Like the Unibus and Q-Bus before it, it uses memory-mapped I/O but has 32-bit address and data paths. The VAXBI is a multiplexed bus with fully distributed arbitration and geographic addressing.

All of the logic required to implement a VAXBI interface is contained within a single custom integrated circuit (the "BIIC") and the physical layout and printed wiring board layout for compliant cards is tightly specified, right down to the location of the dual amber status LEDs that are required. The portion of the card that is reserved for the bus interface is referred to as "the VAXBI corner".[2] VAXBI licensees were given the appropriate engineering drawings to allow them to exactly replicate a compliant card.

VAXBI cards mount into backplanes using a ZIF connector; depending on the backplane design, cards can be loaded from the top or the front side of the backplane. No cable connections are permitted on the cards; all connections are made via three uncommitted rows of backplane connectors. Similarly, no configuration jumpers are permitted on the cards; all setup is done by jumpers inserted on the backplane connectors or via software configuration.

Originally conceived by its engineers to be an open bus, it was forced to be a tightly licensed bus by Digital's marketing and management, and was not nearly as successful as had originally been hoped-for.

It is used in the VAX 6000, VAX 8000 (82xx, 83xx, 85xx, 87xx, 88xx models) and the VAX 9000 systems and also on the MIPS R3000 based DECsystem 5800 series.

A PDP-11 implementation (the PDP-11/27) was envisioned but never advanced beyond the concept stage.

References

  1. ^ VAXBI System Reference Manual (PDF). Digital Equipment Corporation. February 1989.
  2. ^ VAXBI Designer's Notebook (PDF). Digital Equipment Corporation. January 1986.