Jump to content

South African Class NG7 2-6-0

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Andre Kritzinger (talk | contribs) at 14:36, 27 June 2017 (UIC cat). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

CGR Baldwin 2-6-0
South African Class NG7 2-6-0
Baldwin works photograph, c. 1902
Type and origin
Power typeSteam
DesignerBaldwin Locomotive Works
BuilderBaldwin Locomotive Works
Serial number19456, 19649, 19650, 36375
Build date1901-1911
Total produced4
Specifications
Configuration:
 • Whyte2-6-0 (Mogul)
 • UIC1'Cn2
Driver2nd coupled axle
Gauge2 ft (610 mm) narrow
Leading dia.22 in (559 mm)
Coupled dia.33 in (838 mm)
Tender wheels22 in (559 mm)
Wheelbase36 ft 5 in (11,100 mm) ​
 • Axle spacing
(Asymmetrical)
1-2: 4 ft (1,219 mm)
2-3: 3 ft (914 mm)
 • Engine12 ft 10 in (3,912 mm)
 • Coupled7 ft (2,134 mm)
 • Tender13 ft 7 in (4,140 mm)
 • Tender bogie4 ft 1 in (1,245 mm)
Length:
 • Over couplers43 ft 9+34 in (13,354 mm)
Height10 ft 4+34 in (3,169 mm)
Frame typeBar
Axle load:
 • Leading2 LT 4 cwt 2 qtr (2,261 kg)
 • Coupled5 LT 15 cwt 2 qtr (5,868 kg)
 • Tender bogieBogie 1: 10 LT 10 cwt 2 qtr (10,690 kg)
Bogie 2: 10 LT 6 cwt (10,470 kg)
Adhesive weight17 LT 6 cwt 2 qtr (17,600 kg)
Loco weight19 LT 11 cwt (19,860 kg)
Tender weight20 LT 16 cwt 2 qtr (21,160 kg)
Total weight40 LT 7 cwt 2 qtr (41,020 kg)
Tender type2-axle bogies
Fuel typeCoal
Fuel capacity5 LT (5.1 t)
Water cap.1,500 imp gal (6,820 L)
Firebox:
 • TypeRound-top
 • Grate area0.71 m2 (7.6 sq ft)
Boiler:
 • Pitch4 ft 8+38 in (1,432 mm)
 • Diameter3 ft 2+18 in (968 mm)
Boiler pressure180 psi (1,241 kPa)
Safety valveRamsbottom
Heating surface:
 • Firebox3.75 m2 (40.4 sq ft)
 • Tubes35.39 m2 (380.9 sq ft)
 • Total surface39.14 m2 (421.3 sq ft)
CylindersTwo
Cylinder size11+34 in (298 mm) bore
16 in (406 mm) stroke
Valve gearStephenson
CouplersBell-and-hook
Performance figures
Tractive effort9,036 lbf (40.19 kN) @ 75%
Career
OperatorsCape Government Railways
South African Railways
ClassClass NG7
Number in class4
NumbersCGR 1-3, NG4
SAR NG22-NG24, NG35
Delivered1902-1911
First run1902
Withdrawn1926
The 2nd coupled axle had flangeless wheels

The South African Railways Class NG7 2-6-0 of 1902 was a narrow gauge steam locomotive from the pre-Union era in the Cape of Good Hope.

In 1902, the Cape Government Railways placed three steam locomotives with a 2-6-0 Mogul type wheel arrangement in service on the Hopefield narrow gauge branch line which was being constructed from Kalbaskraal. A fourth locomotive was ordered in 1911.[1][2][3]

In 1912, when these locomotives were assimilated into the South African Railways, they were renumbered with an "NG" prefix to their numbers. When a system of grouping narrow gauge locomotives into classes was eventually introduced somewhere between 1928 and 1930, they were to be classified as Class NG7, but had already been withdrawn from service and were eventually sold in 1930.[1][3]

Cape narrow gauge lines

By 1900, the Cape of Good Hope Government began to consider the construction of 2 feet (610 millimetres) narrow gauge railways. The construction of two railways of this gauge, one from Kalbaskraal to Hopefield and another from Port Elizabeth to Avontuur, was sanctioned by the Cape Parliament in 1901. Even though the 2 feet 6 inches (762 millimetres) narrow gauge Namaqualand Railway had been in existence and successfully worked since 1869, the still narrower gauge 46-mile long (74-kilometre) Hopefield line was regarded by many as the pioneer railway of the narrow gauge at the Cape. Its working capacity and attendant advantages and disadvantages were therefore watched with interest throughout the Colony.[2]

Manufacturer

The Cape Government Railways (CGR) ordered three narrow gauge tender locomotives with a 2-6-0 Mogul type wheel arrangement from Baldwin Locomotive Works in 1901. They were numbered 1 to 3 when they were delivered in 1902 and were erected at the Salt River shops. A fourth locomotive, identical to the first three, was ordered from the same manufacturer in 1911 and became CGR no. NG4 upon delivery in that same year.[1][2][3]

Characteristics

The locomotives were of a standard type which was being used on the narrow gauge railroads of Maine in the United States of America. They had bar frames and used Stephenson valve gear. The drivers, the middle wheelset of the coupled wheels, were flangeless to enable the engine to negotiate sharp curves.[1][2]

Service

Cape Government Railways

Baldwin 2-6-0 no. 2 at Hopefield, c. February 1903

The first three locomotives were acquired for use during the construction of the narrow gauge branch line from Kalbaskraal to Hopefield. They remained in service on that line after it was completed in 1903 and were joined by the fourth locomotive in 1911. In 1913, the line was extended to Saldanha, with a branch to Vredenburg. All four locomotives were withdrawn from service when these lines were widened to Cape gauge in 1926.[1][4]

South African Railways

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (CGR, Natal Government Railways and Central South African Railways) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways were only implemented with effect from 1 January 1912.[3][4]

In 1912, narrow gauge locomotives were included in the South African Railways' narrow gauge numbering scheme and were allocated engine numbers prefixed with the letters NG, for narrow gauge. The three 1902 locomotives were allocated SAR numbers NG22 to NG24, while the 1911 locomotive became no. NG35.[3]

First World War

In 1915, shortly after the outbreak of the First World War, the German South West Africa colony was occupied by the Union Defence Forces. Since a large part of the territory's railway infrastructure and rolling stock was destroyed or damaged by retreating German forces, an urgent need arose for locomotives for use on the 600 mm (1 ft 11+58 in) narrow gauge lines in that territory. In 1917, numbers NG22, NG24 and NG35 were transferred to the Defence Department for service in South West Africa. All three are believed to have returned to South Africa after the war.[5]

Narrow gauge classification

A system of grouping narrow gauge locomotives into classes was only adopted by the South African Railways at some time between 1928 and 1930. However, these locomotives did not survive in service long enough to become the Class NG7 which had apparently been reserved for them when the classification system was being planned. Having been out of service since 1926, they were sold to a private firm during 1930.[1][2]

References

  1. ^ a b c d e f Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. pp. 104, 112. ISBN 0869772112.
  2. ^ a b c d e Espitalier, T.J.; Day, W.A.J. (1944). The Locomotive in South Africa - A Brief History of Railway Development. Chapter II - The Cape Government Railways (Continued). South African Railways and Harbours Magazine, April 1944. pp. 253-257.
  3. ^ a b c d e Classification of S.A.R. Engines with Renumbering Lists, issued by the Chief Mechanical Engineer's Office, Pretoria, January 1912, pp. 12, 16, 47 (Reprinted in April 1987 by SATS Museum, R.3125-6/9/11-1000)
  4. ^ a b The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, p. 25.
  5. ^ Espitalier, T.J.; Day, W.A.J. (1947). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VII - South African Railways (Continued). South African Railways and Harbours Magazine, December 1947. p. 1033.