Isotopes of copper
Appearance
Copper (Cu) has two stable isotopes, 63Cu and 65Cu, along with 27 radioisotopes. The most stable of these is 67Cu with a half-life of 61.83 hours. The least stable is 54Cu with a half-life of approximately 75 ns. Most have half-lives under a minute. Unstable copper isotopes with atomic masses below 63 tend to undergo β+ decay, while isotopes with atomic masses above 65 tend to undergo β− decay. 64Cu decays by both β+ and β−.[1]
68Cu, 69Cu, 71Cu, 72Cu, and 76Cu each have one metastable isomer. 70Cu has two isomers, making a total of 7 distinct isomers. The most stable of these is 68mCu with a half-life of 3.75 minutes. The least stable is 69mCu with a half-life of 360 ns.[1]
Standard atomic mass: 63.546(3) u.
Table
nuclide symbol |
Z(p) | N(n) | isotopic mass (u) |
half-life | decay mode(s)[2][n 1] |
daughter isotope(s)[n 2] |
nuclear spin |
representative isotopic composition (mole fraction) |
range of natural variation (mole fraction) |
---|---|---|---|---|---|---|---|---|---|
excitation energy | |||||||||
52Cu | 29 | 23 | 51.99718(28)# | p | 51Ni | (3+)# | |||
53Cu | 29 | 24 | 52.98555(28)# | <300 ns | p | 52Ni | (3/2-)# | ||
54Cu | 29 | 25 | 53.97671(23)# | <75 ns | p | 53Ni | (3+)# | ||
55Cu | 29 | 26 | 54.96605(32)# | 40# ms [>200 ns] | β+ | 55Ni | 3/2-# | ||
p | 54Ni | ||||||||
56Cu | 29 | 27 | 55.95856(15)# | 93(3) ms | β+ | 56Ni | (4+) | ||
57Cu | 29 | 28 | 56.949211(17) | 196.3(7) ms | β+ | 57Ni | 3/2- | ||
58Cu | 29 | 29 | 57.9445385(17) | 3.204(7) s | β+ | 58Ni | 1+ | ||
59Cu | 29 | 30 | 58.9394980(8) | 81.5(5) s | β+ | 59Ni | 3/2- | ||
60Cu | 29 | 31 | 59.9373650(18) | 23.7(4) min | β+ | 60Ni | 2+ | ||
61Cu | 29 | 32 | 60.9334578(11) | 3.333(5) h | β+ | 61Ni | 3/2- | ||
62Cu | 29 | 33 | 61.932584(4) | 9.673(8) min | β+ | 62Ni | 1+ | ||
63Cu | 29 | 34 | 62.9295975(6) | Stable | 3/2- | 0.6915(15) | 0.68983-0.69338 | ||
64Cu | 29 | 35 | 63.9297642(6) | 12.700(2) h | β+ (61%) | 64Ni | 1+ | ||
β- (39%) | 64Zn | ||||||||
65Cu | 29 | 36 | 64.9277895(7) | Stable | 3/2- | 0.3085(15) | 0.30662-0.31017 | ||
66Cu | 29 | 37 | 65.9288688(7) | 5.120(14) min | β- | 66Zn | 1+ | ||
67Cu | 29 | 38 | 66.9277303(13) | 61.83(12) h | β- | 67Zn | 3/2- | ||
68Cu | 29 | 39 | 67.9296109(17) | 31.1(15) s | β- | 68Zn | 1+ | ||
68mCu | 721.6(7) keV | 3.75(5) min | IT (84%) | 68Cu | (6-) | ||||
β- (16%) | 68Zn | ||||||||
69Cu | 29 | 40 | 68.9294293(15) | 2.85(15) min | β- | 69Zn | 3/2- | ||
69mCu | 2741.8(10) keV | 360(30) ns | (13/2+) | ||||||
70Cu | 29 | 41 | 69.9323923(17) | 44.5(2) s | β- | 70Zn | (6-) | ||
70m1Cu | 101.1(3) keV | 33(2) s | β- | 70Zn | (3-) | ||||
70m2Cu | 242.6(5) keV | 6.6(2) s | 1+ | ||||||
71Cu | 29 | 42 | 70.9326768(16) | 19.4(14) s | β- | 71Zn | (3/2-) | ||
71mCu | 2756(10) keV | 271(13) ns | (19/2-) | ||||||
72Cu | 29 | 43 | 71.9358203(15) | 6.6(1) s | β- | 72Zn | (1+) | ||
72mCu | 270(3) keV | 1.76(3) µs | (4-) | ||||||
73Cu | 29 | 44 | 72.936675(4) | 4.2(3) s | β- (>99.9%) | 73Zn | (3/2-) | ||
β-, n (<.1%) | 72Zn | ||||||||
74Cu | 29 | 45 | 73.939875(7) | 1.594(10) s | β- | 74Zn | (1+,3+) | ||
75Cu | 29 | 46 | 74.94190(105) | 1.224(3) s | β- (96.5%) | 75Zn | (3/2-)# | ||
β-, n (3.5%) | 74Zn | ||||||||
76Cu | 29 | 47 | 75.945275(7) | 641(6) ms | β- (97%) | 76Zn | (3,5) | ||
β-, n (3%) | 75Zn | ||||||||
76mCu | 0(200)# keV | 1.27(30) s | β- | 76Zn | (1,3) | ||||
77Cu | 29 | 48 | 76.94785(43)# | 469(8) ms | β- | 77Zn | 3/2-# | ||
78Cu | 29 | 49 | 77.95196(43)# | 342(11) ms | β- | 78Zn | |||
79Cu | 29 | 50 | 78.95456(54)# | 188(25) ms | β-, n (55%) | 78Zn | 3/2-# | ||
β- (45%) | 79Zn | ||||||||
80Cu | 29 | 51 | 79.96087(64)# | 100# ms [>300 ns] | β- | 80Zn |
- ^ Abbreviations:
IT: Isomeric transition - ^ Bold for stable isotopes
Notes
- The precision of the isotope abundances and atomic mass is limited through variations. The given ranges should be applicable to any normal terrestrial material.
- Values marked # are not purely derived from experimental data, but at least partly from systematic trends. Spins with weak assignment arguments are enclosed in parentheses.
- Uncertainties are given in concise form in parentheses after the corresponding last digits. Uncertainty values denote one standard deviation, except isotopic composition and standard atomic mass from IUPAC which use expanded uncertainties
- Nuclide masses are given by IUPAP Commission on Symbols, Units, Nomenclature, Atomic Masses and Fundamental Constants (SUNAMCO)
- Isotope abundances are given by IUPAC Commission on Isotopic Abundances and Atomic Weights
References
- ^ a b
G. Audi, A. H. Wapstra, C. Thibault, J. Blachot and O. Bersillon (2003). "The NUBASE evaluation of nuclear and decay properties" (PDF). Nuclear Physics A. 729: 3–128. Bibcode:2003NuPhA.729....3A. doi:10.1016/j.nuclphysa.2003.11.001.
{{cite journal}}
: CS1 maint: multiple names: authors list (link) - ^ Nucleonica: Universal Nuclide Chart
- Isotope masses from:
- G. Audi, A. H. Wapstra, C. Thibault, J. Blachot and O. Bersillon (2003). "The NUBASE evaluation of nuclear and decay properties" (PDF). Nuclear Physics A. 729: 3–128. Bibcode:2003NuPhA.729....3A. doi:10.1016/j.nuclphysa.2003.11.001.
{{cite journal}}
: CS1 maint: multiple names: authors list (link)
- G. Audi, A. H. Wapstra, C. Thibault, J. Blachot and O. Bersillon (2003). "The NUBASE evaluation of nuclear and decay properties" (PDF). Nuclear Physics A. 729: 3–128. Bibcode:2003NuPhA.729....3A. doi:10.1016/j.nuclphysa.2003.11.001.
- Isotopic compositions and standard atomic masses from:
- J. R. de Laeter, J. K. Böhlke, P. De Bièvre, H. Hidaka, H. S. Peiser, K. J. R. Rosman and P. D. P. Taylor (2003). "Atomic weights of the elements. Review 2000 (IUPAC Technical Report)". Pure and Applied Chemistry. 75 (6): 683–800. doi:10.1351/pac200375060683.
{{cite journal}}
: CS1 maint: multiple names: authors list (link) - M. E. Wieser (2006). "Atomic weights of the elements 2005 (IUPAC Technical Report)". Pure and Applied Chemistry. 78 (11): 2051–2066. doi:10.1351/pac200678112051.
{{cite journal}}
: Unknown parameter|laysummary=
ignored (help)
- J. R. de Laeter, J. K. Böhlke, P. De Bièvre, H. Hidaka, H. S. Peiser, K. J. R. Rosman and P. D. P. Taylor (2003). "Atomic weights of the elements. Review 2000 (IUPAC Technical Report)". Pure and Applied Chemistry. 75 (6): 683–800. doi:10.1351/pac200375060683.
- Half-life, spin, and isomer data selected from the following sources. See editing notes on this article's talk page.
- G. Audi, A. H. Wapstra, C. Thibault, J. Blachot and O. Bersillon (2003). "The NUBASE evaluation of nuclear and decay properties" (PDF). Nuclear Physics A. 729: 3–128. Bibcode:2003NuPhA.729....3A. doi:10.1016/j.nuclphysa.2003.11.001.
{{cite journal}}
: CS1 maint: multiple names: authors list (link) - National Nuclear Data Center. "NuDat 2.1 database". Brookhaven National Laboratory. Retrieved September 2005.
{{cite web}}
: Check date values in:|accessdate=
(help) - N. E. Holden (2004). "Table of the Isotopes". In D. R. Lide (ed.). CRC Handbook of Chemistry and Physics (85th ed.). CRC Press. Section 11. ISBN 978-0-8493-0485-9.
{{cite book}}
: Unknown parameter|nopp=
ignored (|no-pp=
suggested) (help)
- G. Audi, A. H. Wapstra, C. Thibault, J. Blachot and O. Bersillon (2003). "The NUBASE evaluation of nuclear and decay properties" (PDF). Nuclear Physics A. 729: 3–128. Bibcode:2003NuPhA.729....3A. doi:10.1016/j.nuclphysa.2003.11.001.