Sodium-cooled fast reactor

The sodium-cooled fast reactor or SFR is a Generation IV reactor project to design an advanced fast neutron reactor.

It builds on two closely related existing projects, the LMFBR and the Integral Fast Reactor, with the objective of producing a fast-spectrum, sodium-cooled reactor.

The reactors are intended for use in nuclear power plants to produce nuclear power from nuclear fuel.

Fuel cycle

The nuclear fuel cycle employs a full actinide recycle with two major options: One is an intermediate-size (150–600 MWe) sodium-cooled reactor with uranium-plutonium-minor-actinide-zirconium metal alloy fuel, supported by a fuel cycle based on pyrometallurgical reprocessing in facilities integrated with the reactor. The second is a medium to large (500–1,500 MWe) sodium-cooled reactor with mixed uranium-plutonium oxide fuel, supported by a fuel cycle based upon advanced aqueous processing at a central location serving a number of reactors. The outlet temperature is approximately 510–550 degrees Celsius for both.

Sodium as a coolant

Advantages

An advantage of liquid metal coolants is high heat capacity which provides thermal inertia against overheating.^[1] Water is difficult to use as a coolant for a fast reactor because water acts as a neutron moderator that slows the fast neutrons into thermal neutrons. While it may be possible to use supercritical water as a coolant in a fast reactor, this would require a very high pressure. In contrast, sodium atoms are much heavier than both the oxygen and hydrogen atoms found in water, and therefore the neutrons lose less energy in collisions with sodium atoms. Sodium also need not be pressurized since its boiling point is much higher than the reactor's operating temperature, and sodium does not corrode steel reactor parts.^[1]

Disadvantages

A disadvantage of sodium is its chemical reactivity, which requires special precautions to prevent and suppress fires. If sodium comes into contact with water it explodes, and it burns when in contact with air. This was the case at the Monju Nuclear Power Plant in a 1995 accident. In addition, neutrons cause it to become radioactive; however, activated sodium has a half-life of only 15 hours.^[1]

Design goals

The operating temperature should not exceed the melting temperature of the fuel. Fuel-to-cladding chemical interaction (FCCI) has to be designed against. FCCI is eutectic melting between the fuel and the cladding; uranium, plutonium, and lanthanum (a fission product) inter-diffuse with the iron of the cladding. The alloy that forms has a low eutectic melting temperature. FCCI causes the cladding to reduce in strength and could eventually rupture. The amount of transuranic transmutation is limited by the production of plutonium from uranium. A design work-around has been proposed to have an inert matrix. Magnesium oxide has been proposed as the inert matrix. Magnesium oxide has an entire order of magnitude smaller probability of interacting with neutrons (thermal and fast) than elements like iron.^[2]

Actinides and fission products by half-life v t e
Actinides^[3] by decay chain				Half-life range (a)	Fission products of ²³⁵U by yield^[4]
4n	4n + 1	4n + 2	4n + 3	Half-life range (a)	4.5–7%	0.04–1.25%	<0.001%
²²⁸Ra^№				4–6 a		¹⁵⁵Eu^þ
²⁴⁴Cm^ƒ	²⁴¹Pu^ƒ	²⁵⁰Cf	²²⁷Ac^№	10–29 a	⁹⁰Sr	⁸⁵Kr	^113mCd^þ
²³²U^ƒ		²³⁸Pu^ƒ	²⁴³Cm^ƒ	29–97 a	¹³⁷Cs	¹⁵¹Sm^þ	^121mSn
²⁴⁸Bk^[5]	²⁴⁹Cf^ƒ	^242mAm^ƒ		141–351 a	No fission products have a half-life in the range of 100 a–210 ka ...
	²⁴¹Am^ƒ		²⁵¹Cf^ƒ^[6]	430–900 a
		²²⁶Ra^№	²⁴⁷Bk	1.3–1.6 ka
²⁴⁰Pu	²²⁹Th	²⁴⁶Cm^ƒ	²⁴³Am^ƒ	4.7–7.4 ka
	²⁴⁵Cm^ƒ	²⁵⁰Cm		8.3–8.5 ka
			²³⁹Pu^ƒ	24.1 ka
		²³⁰Th^№	²³¹Pa^№	32–76 ka
²³⁶Np^ƒ	²³³U^ƒ	²³⁴U^№		150–250 ka	⁹⁹Tc^₡	¹²⁶Sn
²⁴⁸Cm		²⁴²Pu		327–375 ka		⁷⁹Se^₡
				1.53 Ma	⁹³Zr
	²³⁷Np^ƒ			2.1–6.5 Ma	¹³⁵Cs^₡	¹⁰⁷Pd
²³⁶U			²⁴⁷Cm^ƒ	15–24 Ma		¹²⁹I^₡
²⁴⁴Pu				80 Ma	... nor beyond 15.7 Ma^[7]
²³²Th^№		²³⁸U^№	²³⁵U^ƒ№	0.7–14.1 Ga	... nor beyond 15.7 Ma^[7]
₡, has thermal neutron capture cross section in the range of 8–50 barns ƒ, fissile №, primarily a naturally occurring radioactive material (NORM) þ, neutron poison (thermal neutron capture cross section greater than 3k barns)

The SFR is designed for management of high-level wastes and, in particular, management of plutonium and other actinides. Important safety features of the system include a long thermal response time, a large margin to coolant boiling, a primary system that operates near atmospheric pressure, and intermediate sodium system between the radioactive sodium in the primary system and the water and steam in the power plant. With innovations to reduce capital cost, such as making a modular design, removing a primary loop, integrating the pump and intermediate heat exchanger, or simply find better materials for construction, the SFR can be a viable technology for electricity generation.^[8]

The SFR's fast spectrum also makes it possible to use available fissile and fertile materials (including depleted uranium) considerably more efficiently than thermal spectrum reactors with once-through fuel cycles.

Reactors

Sodium-cooled reactors have included:

BN-350 reactor, Russia
BN-600 reactor, Russia (operational as of 2013). Pool design.
BN-800 reactor, Russia (under construction as of 08.2013, first criticality expected in late 2013)
China Experimental Fast Reactor (operational as of 2013)
Clinch River Breeder Reactor Project, United States
Dounreay Prototype Fast Reactor, United Kingdom
Fermi 1, United States
Experimental Breeder Reactor I, United States
Experimental Breeder Reactor II, United States. Pool design.
Fast Breeder Test Reactor, India

Jōyō, Japan
Monju Nuclear Power Plant, Japan (reported to be restarted in late 2013-2014). Loop design.
Phénix, France. Pool design.
Prototype Fast Breeder Reactor, India (under construction, reported criticality in 2014)
S1G and S2G, United States Navy
SNR-300, Germany
Sodium Reactor Experiment, United States
Superphénix, France
Rapsodie, France

Most of these were experimental plants, which are no longer operational

Fast Flux Test Facility, United States, a sodium-cooled fast neutron reactor

References

^ ^a ^b ^c Fanning, Thomas H. (May 3, 2007). "Sodium as a Fast Reactor Coolant" (PDF). Topical Seminar Series on Sodium Fast Reactors. Nuclear Engineering Division, U.S. Nuclear Regulatory Commission, U.S. Department of Energy.
^ Bays SE, Ferrer RM, Pope MA, Forget B (February 2008). "Neutronic Assessment of Transmutation Target Compositions in Heterogeneous Sodium Fast Reactor Geometries" (PDF). Idaho National Laboratory, U.S. Department of Energy. INL/EXT-07-13643 Rev. 1.{{cite web}}: CS1 maint: multiple names: authors list (link)
^ Plus radium (element 88). While actually a sub-actinide, it immediately precedes actinium (89) and follows a three-element gap of instability after polonium (84) where no nuclides have half-lives of at least four years (the longest-lived nuclide in the gap is radon-222 with a half life of less than four days). Radium's longest lived isotope, at 1,600 years, thus merits the element's inclusion here.
^ Specifically from thermal neutron fission of uranium-235, e.g. in a typical nuclear reactor.
^ Milsted, J.; Friedman, A. M.; Stevens, C. M. (1965). "The alpha half-life of berkelium-247; a new long-lived isomer of berkelium-248". Nuclear Physics. 71 (2): 299. Bibcode:1965NucPh..71..299M. doi:10.1016/0029-5582(65)90719-4.
"The isotopic analyses disclosed a species of mass 248 in constant abundance in three samples analysed over a period of about 10 months. This was ascribed to an isomer of Bk²⁴⁸ with a half-life greater than 9 [years]. No growth of Cf²⁴⁸ was detected, and a lower limit for the β⁻ half-life can be set at about 10⁴ [years]. No alpha activity attributable to the new isomer has been detected; the alpha half-life is probably greater than 300 [years]."
^ This is the heaviest nuclide with a half-life of at least four years before the "sea of instability".
^ Excluding those "classically stable" nuclides with half-lives significantly in excess of ²³²Th; e.g., while ^113mCd has a half-life of only fourteen years, that of ¹¹³Cd is eight quadrillion years.
^ Lineberry MJ, Allen TR (October 2002). "The Sodium-Cooled Fast Reactor (SFR)" (PDF). Argonne National Laboratory, US Department of Energy. ANL/NT/CP-108933.

External links

Idaho National Laboratory Sodium-cooled Fast Reactor Fact Sheet
Generation IV International Forum SFR website
INL SFR workshop summary
ALMR/PRISM
Richardson JH (November 17, 2009). "Meet the Man Who Could End Global Warming". Esquire. ... Eric Loewen is the evangelist of the sodium fast reactor, which burns nuclear waste, emits no CO₂, ...

[sodiumcoolant-1] Fanning, Thomas H. (May 3, 2007). "Sodium as a Fast Reactor Coolant" (PDF). Topical Seminar Series on Sodium Fast Reactors. Nuclear Engineering Division, U.S. Nuclear Regulatory Commission, U.S. Department of Energy.

[2] Bays SE, Ferrer RM, Pope MA, Forget B (February 2008). "Neutronic Assessment of Transmutation Target Compositions in Heterogeneous Sodium Fast Reactor Geometries" (PDF). Idaho National Laboratory, U.S. Department of Energy. INL/EXT-07-13643 Rev. 1.{{cite web}}: CS1 maint: multiple names: authors list (link)

[3] Plus radium (element 88). While actually a sub-actinide, it immediately precedes actinium (89) and follows a three-element gap of instability after polonium (84) where no nuclides have half-lives of at least four years (the longest-lived nuclide in the gap is radon-222 with a half life of less than four days). Radium's longest lived isotope, at 1,600 years, thus merits the element's inclusion here.

[4] Specifically from thermal neutron fission of uranium-235, e.g. in a typical nuclear reactor.

[5] Milsted, J.; Friedman, A. M.; Stevens, C. M. (1965). "The alpha half-life of berkelium-247; a new long-lived isomer of berkelium-248". Nuclear Physics. 71 (2): 299. Bibcode:1965NucPh..71..299M. doi:10.1016/0029-5582(65)90719-4.
"The isotopic analyses disclosed a species of mass 248 in constant abundance in three samples analysed over a period of about 10 months. This was ascribed to an isomer of Bk²⁴⁸ with a half-life greater than 9 [years]. No growth of Cf²⁴⁸ was detected, and a lower limit for the β⁻ half-life can be set at about 10⁴ [years]. No alpha activity attributable to the new isomer has been detected; the alpha half-life is probably greater than 300 [years]."

[6] This is the heaviest nuclide with a half-life of at least four years before the "sea of instability".

[7] Excluding those "classically stable" nuclides with half-lives significantly in excess of ²³²Th; e.g., while ^113mCd has a half-life of only fourteen years, that of ¹¹³Cd is eight quadrillion years.

[8] Lineberry MJ, Allen TR (October 2002). "The Sodium-Cooled Fast Reactor (SFR)" (PDF). Argonne National Laboratory, US Department of Energy. ANL/NT/CP-108933.

[1]

[2]

[3]

[4]

[5]

[6]

[7]

[8]