Jump to content

Buttonhole

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Blairall (talk | contribs) at 16:54, 28 September 2023 (Clean up/copyedit). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

For other uses, see Buttonhole (disambiguation).
Machine-stitched keyhole buttonhole with bar

A buttonhole is a reinforced hole in fabric that a button can pass through, allowing one piece of fabric to be secured to another. The raw edges of a buttonhole are usually finished with stitching. This may be done either by hand or by a sewing machine. Some forms of button, such as a frog, use a loop of cloth or rope instead of a buttonhole.[1]

The term buttonhole can also refer to a flower worn in the lapel buttonhole of a coat or jacket, which is referred to simply as a "buttonhole" or "boutonnière".[2]

History

Buttonholes for fastening or closing clothing with buttons appeared first in Germany during the 13th century. However, it is believed that ancient Persians used them first.[3] They soon became widespread with the rise of snug-fitting garments in 13th- and 14th-century Europe.[citation needed]

Aspects of buttonholes

Buttonholes often have a bar of stitches at either side of them. This is a row of perpendicular hand or machine stitching to reinforce the raw edges of the fabric, and to prevent it from fraying.[4]

Traditionally, men's clothing buttonholes are on the left side, and women's clothing buttonholes are on the right.[5] The lore of this 'opposite' sides buttoning is that the practice came into being as 'women of means' had chamber maids who dressed them. So as not to confuse the poor chamber maids, the wealthy began having women's garments made with the buttons and holes 'switched'; the birth of the modern ladies' blouse. The chamber maids themselves, as did most all the common class, both male and female, actually wore 'shirts' with buttons and holes placed as on men's clothing. There appears to be no concrete reference to prove or disprove this story, but its plausibility bears noting.[6][7]

Types of buttonholes

A machine-made buttonhole.
A bound buttonhole. The inset fabric panels are called welts.

Hand stitching

  • A plain buttonhole is one in which the raw (cut) edges of the textile are finished with thread in very closely spaced stitches, typically the buttonhole stitch. When stitched by hand, a slit is made in the fabric first and the result is called a hand-worked buttonhole or worked buttonhole.[8] The buttonhole construction sometimes includes a technique called stranding where a flat piece of gimp cord or thread is incorporated into the edges to act as a reinforcement.[9]
  • A Milanese buttonhole: after the hole for the button is cut, a length of silk thread called a gimp is laid around the edges. A glossier buttonhole thread is then wrapped around the gimp and sewn through the cloth surrounding the buttonhole. It is used in bespoke menswear as a detail to embellish the jacket because it serves no purpose other than to hold lapel pins and flowers.[10]

Machined stitching

Sewing machines offer various levels of automation to creating plain buttonholes. When made by machine, the slit between the sides of the buttonhole is opened after the stitching is completed.[11]

  • A machine-made buttonhole is usually sewn with two parallel rows of machine sewing in a narrow zig-zag stitch, with the ends finished in a bar tack created using a broader zig-zag stitch.[12] One of the first automatic buttonhole machines was invented by Henry Alonzo House in 1862.[13]
  • A bound buttonhole is one which has its raw edges encased by pieces of fabric or trim instead of stitches.[14][15]
  • A keyhole buttonhole is a special case of a thread-finished buttonhole that has a round hole at the end of the buttonhole slit, reinforced with a fan-shaped array of stitches. Because a button-closed gap in a garment is normally under some stress, the button will tend to move towards the end of the buttonhole closest to the gap in the garment.[16] A keyhole at the end of the buttonhole closest to the gap accommodates the button's shank without distorting the fabric. Keyhole buttonholes are most often found on tailored coats and jackets.[12] This buttonhole is normally machine-made due to the difficulty of achieving it by hand working.

See also

References

Citations

  1. ^ Shaeffer 2007, pp. 91–93.
  2. ^ Boyana, Ivanova (30 March 2018). "The lapel buttonhole - purpose, history and usage". Be Global Fashion Network. Fashion.bg Ltd. Retrieved 1 April 2019.
  3. ^ White, Lynn (Autumn 1962). "The Act of Invention: Causes, Contexts, Continuities and Consequences". Technology and Culture. 3 (4). The Johns Hopkins University Press and the Society for the History of Technology: 486–500. doi:10.2307/3100999. JSTOR 3100999.
  4. ^ Singer 2005, pp. 138–9.
  5. ^ Shaeffer 1981, p. 144.
  6. ^ Finney, Lauren (13 July 2016). "Here's why men's and women's shirts button on the opposite sides". Today. NBC Universal. Retrieved 1 April 2019.
  7. ^ Turk, Victoria (25 March 2016). "Right for Men, Left for Women: Why Are Gendered Buttons Still a Thing?". Motherboard. Vice Media LLC. Retrieved 1 April 2019.
  8. ^ Whitlock & Phillips 1922, pp. 22–26.
  9. ^ Shaeffer 2007, p. 89.
  10. ^ Zottolo, Peter (19 July 2017). "The Milanese Buttonhole: Beautifully Unnecessary". The Styleforum Journal. Retrieved 4 September 2017.
  11. ^ Singer 2005, p. 139.
  12. ^ a b Singer 2005, p. 138.
  13. ^ Gregory, Martin (March 2012). "The House Brothers and their contribution to the sewing machine". ISMACS News. No. 106. International Sewing Machine Collectors Society. Retrieved 1 April 2019.
  14. ^ Shaeffer 1981, pp. 144–152.
  15. ^ Whitlock & Phillips 1922, pp. 26–28.
  16. ^ Whitlock & Phillips 1922, p. 23.

Bibliography


Retrieved from "https://en.wikipedia.org/w/index.php?title=Buttonhole&oldid=1177638839"