Jump to content

AN/FPS-6 Radar

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Ktr101 (talk | contribs) at 06:18, 17 January 2016 (removed Category:Military radars of the United States Air Force; added Category:Radars of the United States Air Force using HotCat). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

AN/FPS-6
General Electric AN/FPS-6 Radar
Country of originUnited States
TypeLong-Range Height Finder Radar
Other NamesAN/MPS-14 (Mobile version)

The AN/FPS-6 Radar was a long-range height finding radar used by the United States Air Force's Air Defense Command. The AN/FPS-6 radar was introduced into service in the late 1950s and served as the principal height-finder radar for the United States for several decades thereafter. It was also used by the Royal Air Force alongside their Type 80 radars. Built by General Electric, the S-band radar operated on a frequency of 2700 to 2900 MHz. Between 1953 and 1960, about 450 units of the AN/FPS-6 and the mobile AN/MPS-14 version were produced. The AN/FPS-90 and AN/FPS-116 radars were identical to the AN/FPS-6 except for receiver modifications.

Operation

The radar consisted of an antenna group, a transmitter group, a receiver group, and an ancillary group. Most fixed sites had a remote group, which allowed the control of the radar from inside the operations center. Also located in operations, was the anti-jam receivers. These receivers were fed with raw video from the tower receiver, and output several types of processed video to enable operators to see through jamming.

The ancillary group originally consisted of an AN/OA-270 Range Height Indicator (RHI), and then later upgraded to an AN/OA-929 RHI, which displayed the raw or anti-jam video, and allowed the operator to position the azimuth of the antenna. At SAGE sites, the antenna azimuth was selected by command from the Air Division, and the operator could slew the antenna plus or minus ten degrees for fine adjustment.

The AN/FPS-90 radar was designated a high-power model, using a QK-338A magnetron and rated at 4.5 MW peak power, versus the QK-327A magnetron at 3.5 MW peak power. The receiver mixer was also modified to handle the larger signal dynamic range. Due to maintenance costs and high failure rates, these radars were all retrofitted to the same magnetron as the AN/FPS-6 by the late 1960s, and were no longer high power. The radar maintained its AN/FPS-90 designation due to the receiver modifications. Everything else was identical.

See also