Zond 1

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by CommonsDelinker (talk | contribs) at 17:30, 18 August 2018 (Removing Zond1.gif, it has been deleted from Commons by Taivo because: Copyright violation; see c:Commons:Licensing (F1): c:Commons:Deletion requests/File:Zond1.gif.). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Zond 1
NamesZond 3MV-1 No. 4
Mission typeVenus lander
OperatorOKB-1
COSPAR ID1964-016D Edit this at Wikidata
SATCAT no.00785
Spacecraft properties
Bus3MV-1
Launch mass890 kg (1,960 lb)
Dry mass290 kilograms (640 lb)
Dimensions3.6 m (12 ft) tall
1.1 m (3 ft 7 in) diameter
Start of mission
Launch date02:42:40, April 2, 1964 (1964-04-02T02:42:40)
RocketMolniya 8K78M
Launch siteBaikonur LC-1/5
End of mission
Last contactMay 24, 1964 (1964-05-24)
Orbital parameters
Reference systemHeliocentric
Perihelion altitude0.652 AU
Aphelion altitude1.001 AU
Inclination3.7°
Period274 days
Flyby of Venus
Closest approach19 July 1964
Distance100,000 km (62,000 mi)
← program started
Zond 2 →
 


Zond 1 was a spacecraft of the Soviet Zond program. It was the second Soviet research spacecraft to reach Venus, although communications had failed by that time. It carried a 90 cm spherical landing capsule, containing experiments for chemical analysis of the atmosphere, gamma-ray measurements of surface rocks, a photometer, temperature and pressure gauges, and a motion/rocking sensor in case it landed in water.

History

At least three previous Soviet planetary probes had been lost due to malfunctions of the ullage rockets (BOZ) on the Blok L stage, but an investigation found that the problem was easily resolved. The spacecraft, a Venera 3MV-1, was launched on April 2, 1964 from Tyuratam and this time the launch vehicle performed flawlessly. During the cruise phase, a slow leak from a cracked sensor window caused the electronics compartment to lose air pressure. This was a serious problem as Soviet electronics relied on vacuum tubes which would overheat without cooling air. An ill-timed command from ground control turned on its radio system while there was still a rarefied atmosphere inside, causing the electronics to short out by corona discharge. Since the mission could not succeed, it was unacceptable to give it a Venera designation, but as the probe had exited Earth orbit, it also could not be given the Kosmos cover name, so Soviet authorities instead announced the probe as "Zond" and claimed that it was designed to "stress-test components in deep space". Chief Designer Sergei Korolev was upset at the failure of the mission and demanded higher quality control from the OKB-1 Bureau, including X-rays to test for pressure leaks.

By mid-April, the electronics in the main spacecraft had completely failed and all signal transmission ceased, but communication via the lander could still be performed, and space radiation and atomic-hydrogen spectrometer measurements were received. The star trackers in the spacecraft were also used to align it for a course-correction burn, but the second one was off by 65 feet per second (20 meters per second). Also one of the star trackers failed, forcing ground controllers to place Zond 1 into a spin-stabilization mode. However, all communications had failed by May 14. It passed 100,000 km from Venus on July 14, 1964.

See also

External links

Preceded by
None
Zond program (interplanetary) Succeeded by
Zond 2