Jump to content

SPARCclassic

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by DigitalIceAge (talk | contribs) at 00:05, 5 July 2024 (External links: {{Sun Microsystems}}). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

SPARCclassic X, an X terminal based on the SPARCclassic workstation

The SPARCclassic (Sun 4/15) is a workstation introduced by Sun Microsystems in November 1992. It is based on the sun4m architecture, and is enclosed in a lunchbox chassis. It shares the code name Sunergy with the SPARCclassic X, SPARCstation LX, and SPARCstation ZX.[1] It was replaced by the SPARCstation 4 in February 1994.

Specifications

CPU support

The SPARCclassic incorporates a single 50 MHz microSPARC processor.

Memory

The SPARCclassic has three banks with two DSIMM slots each. The official maximum configuration uses 16 MB modules, but the first bank can also hold 32 MB modules giving a maximum of 128MB memory.

Disk drives

The SPARCclassic can hold one internal 3.5-inch 50-pin, single ended, fast-narrow SCSI drive and a floppy. It also supports external SCSI devices. There is no IDE/ATAPI support.

Network support

The SPARCclassic comes with an on-board AMD Lance Ethernet chipset providing 10BASE-T networking as standard and 10BASE2 and 10BASE5 via an AUI transceiver. The OpenBoot ROM is able to boot from network, using RARP and TFTP. Like all other SPARCstation systems, the SPARCclassic holds system information such as MAC address and serial number in NVRAM. If the battery on this chip dies, then the system will not be able to boot.

Dimensions

Its dimensions are 9.6 in (24 cm) x 10.4 in (26 cm) x 4.6 in (12 cm) (W x D x H). The weight is 11 lb (5.0 kg).[2]

Operating systems

The following operating systems run on a SPARCclassic:

  • SunOS 4.1.3c onwards
  • Solaris 2.3 Edition II to Solaris 9
  • Linux - Some but not all distributions still support this sparc32 sub-architecture
  • NetBSD/sparc32
  • OpenBSD/sparc32

Differences between Classic and LX

The SPARCclassic was designed to be an entry-level workstation with a lower price point than the SPARCstation LX; it has a lower-end CG3 framebuffer rather than the LX's accelerated CG6. The SPARCclassic also features 8-bit audio as opposed to 16-bit audio for the LX. The motherboards of the two systems are otherwise similar, and both use the same chassis.

SPARCclassic X

In July 1993, Sun introduced the SPARCclassic X, a stripped-down SPARCclassic marketed as an X terminal. It shipped with no local storage, and either 4 or 8 MB of memory.[3]

Rather than running Solaris, the SPARCclassic X loaded and ran special software over the network.

Sun offered an upgrade kit to a full workstation that included a hard drive and additional memory.

See also

References

  1. ^ "Sun-4/10/15/30 Handbook - Contents". www.shrubbery.net.
  2. ^ SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual (PDF). Sun Microsystems, Inc. November 1993. p. A-3. Retrieved 10 July 2023.
  3. ^ "Sun's SPARCclassic X System Is Upgradable to a Workstation" (Press release). Sun Microsystems, Inc. June 30, 1993. Archived from the original on March 4, 2016. Retrieved 2012-10-11.