Jump to content

UA120

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Brickmack (talk | contribs) at 14:51, 27 February 2016 (←Created page with '450px|thumbnail|Launch of a [[Titan 34D with two UA1206 boosters]] '''UA120''' was a family of American ...'). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

(diff) ← Previous revision | Latest revision (diff) | Newer revision → (diff)
Launch of a Titan 34D with two UA1206 boosters

UA120 was a family of American solid-fueled rocket stages, manufactured by the Chemical Systems Division of United Aircraft (later United Technologies Corporation). Several variants existed, with a varying number of segments.

Design

Schematic of the UA120 booster

All versions of UA120 shared a common design, with the only significant differentiating factor being the length of the motor. It was a segmented design, with between five and seven motor segments possible. A solid propellant, polybutadiene acrylonitrile, was used as fuel.[1] The stage had an external diameter of 120 inches.[2] Attitude control in flight was provided by means of a hydraulic thrust vector control system, with an external nacelle containing hydraulic fluid attached to the side of each booster.[2] Solid fueled separation rockets, used to jettison the spent boosters, were affixed at the top and bottom of the stage.[2] Thrust-termination capability, necessary for manned rockets such as the Space Shuttle or Manned Orbiting Laboratory, was to be provided by by two pyrotechnically triggered ports on the forward closure, which when opened would allow for the non-propulsive venting of exhaust gasses.[3] The forward end of the stage contained an aerodynamic nose cone, an ignitor, separation rockets, and the forward attachment ring. The aft end contained additional separation rockets, the nozzle, and a heat shield.[2]

Variants

The overall design of each variant was very similar, the main difference being the number of segments used. This is indicated by the number at the end of each designation.

UA1205

UA1205 was used as a strap-on booster on the Titan IIIC, Titan IIID, and Titan IIIE rockets, and was proposed for use on several derivatives of the Saturn rocket family.[1][2]

UA1206

The UA1206 was used as a strap-on booster on Titan 34D and Commercial Titan III.[4]

UA1207

UA1207 was used on Titan IV-A. It was proposed for several other variants of Titan III and IV, as well as derivatives of the Saturn rocket family and the Space Shuttle.[5][3][2]

References

  1. ^ a b "UA1205". Astronautix. Retrieved 26 February 2016.
  2. ^ a b c d e f "A STUDY OF PERFORMANCE AND COST IMPROVEMENT POTENTIAL OF THE 120-IN.- (3.05 M) DIAMETER SOLID ROCKET MOTOR" (PDF). United Aircraft Corporation. December 1971. Retrieved 26 February 2016.
  3. ^ a b "Study of Solid Rocket Motors for a Space Shuttle Booster" (PDF). United Technology Center. 15 March 1972. Retrieved 26 February 2016.
  4. ^ "Titan UA1206". Astronautix. Retrieved 26 February 2016.
  5. ^ "UA1207". Astronautix. Retrieved 26 February 2016.
Retrieved from "https://en.wikipedia.org/w/index.php?title=UA120&oldid=707216550"