Jump to content

Henry (Martian crater)

Coordinates: 10°54′N 23°18′E / 10.9°N 23.3°E / 10.9; 23.3
From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Jstuby (talk | contribs) at 01:46, 4 July 2020 (nearby craters). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

Henry
Location of Henry crater
PlanetMars
RegionArabia quadrangle
Coordinates10°54′N 23°18′E / 10.9°N 23.3°E / 10.9; 23.3
QuadrangleArabia
Diameter171 km
EponymPaul Henry and Prosper Henry

Henry is a large crater in the Arabia quadrangle of Mars. It is 171 kilometres (106 mi) in diameter and was named after the brothers Paul Henry and Prosper Henry, both of whom were French telescope makers and astronomers.[1]

Arago crater is to the east of Henry, Barth crater is to the southeast, and Pasteur crater is to the north.

Layers

Henry crater has a large mound in its center that shows layers in certain parts.[2] The layers can be a few meters thick or tens of meters think. Recent research on these layers by scientists at California Institute of Technology (Caltech) suggest that ancient climate change on Mars caused by regular variation in the planet's tilt, or obliquity may have caused the patterns in the layers. On Earth, similar changes (astronomical forcing) of climate results in ice-age cycles.

In a recent study of layers in craters in western Arabia Terra much was learned about the layers. Each layer may average under 4 meters in one crater, but 20 meters in another. Although the craters in this study are just outside the boundary for the Arabia quadrangle the findings would probably apply to the Arabia quadrangle as well. The pattern of layers within layers measured in Becquerel crater, suggests that each layer was formed over a period of about 100,000 years. Moreover, every 10 layers were bundled together into larger units. The 10-layer pattern is repeated at least 10 times. So every 10-layer pattern took one-million-year years to form.

It is believed that the regular pattern of layers in Arabia Terra is connected to the regular way in which the rotational axis of Mars changes. The tilt of the Earth's axis changes by only a little more than 2 degrees. In contrast Mars's tilt varies by tens of degrees. When the tilt (or obliquity) is low, the poles are the coldest places on the planet, while the sun is located near the equator all the time. This could cause gases in the atmosphere, like water and carbon dioxide, to migrate poleward, where they'd be locked up as ice. When the obliquity is higher, the poles receive more sunlight, causing those materials to migrate away. When carbon dioxide moves from the poles, the atmospheric pressure increases, maybe causing a difference in the ability of winds to transport and deposit sand. Also, with more water in the atmosphere sand grains may stick and cement together to form layers. This study was done using stereo topographic maps obtained by processing data from the high-resolution camera onboard NASA's Mars Reconnaissance Orbiter.[3]

Another group of researchers proposed groundwater with dissolved minerals came to the surface in craters, and helped to form layers by adding minerals (especially sulfate) and cementing sediments. This hypothesis is supported by a groundwater model and by sulfates discovered in a wide area.[4][5] At first, by examining surface materials with Opportunity Rover, scientists discovered that groundwater had repeatedly risen and deposited sulfates.[6][7][8][9][10] Later studies with instruments on board the Mars Reconnaissance Orbiter showed that the same kinds of materials exist in a large area that included Arabia.[11] In this model, the layers in the mound of Henry would be caused partly by sediments moving into the crater and partly by minerals rising up with groundwater and being deposited.

See also

References

  1. ^ "Henry". Gazetteer of Planetary Nomenclature. USGS Astrogeology Research Program.
  2. ^ Grotzinger, J. and R. Milliken (eds.) 2012. Sedimentary Geology of Mars. SEPM
  3. ^ http://www.spaceref.com:80/news/viewpr.html.pid=27101[permanent dead link]
  4. ^ Andrews‐Hanna, J. C., R. J. Phillips, and M. T. Zuber (2007), Meridiani Planum and the global hydrology of Mars, Nature, 446, 163–166, doi:10.1038/nature05594.
  5. ^ Andrews‐Hanna, J. C., M. T. Zuber, R. E. Arvidson, and S. M. Wiseman (2010), Early Mars hydrology: Meridiani playa deposits and the sedimentary record of Arabia Terra, J. Geophys. Res., 115, E06002, doi:10.1029/2009JE003485.
  6. ^ "Opportunity Rover Finds Strong Evidence Meridiani Planum Was Wet". Retrieved July 8, 2006.
  7. ^ Grotzinger, J. P., et al. (2005), Stratigraphy and sedimentology of a dry to wet eolian depositional system, Burns formation, Meridiani Planum, Mars, Earth Planet. Sci. Lett., 240, 11–72, doi:10.1016/j.epsl.2005.09.039
  8. ^ McLennan, S. M., et al. (2005), Provenance and diagenesis of the evaporitebearing Burns formation, Meridiani Planum, Mars, Earth Planet. Sci. Lett., 240, 95–121, doi:10.1016/j.epsl.2005.09.041
  9. ^ Squyres, S. W., and A. H. Knoll (2005), Sedimentary rocks at Meridiani Planum: Origin, diagenesis, and implications for life on Mars, Earth Planet. Sci. Lett., 240, 1–10, doi:10.1016/j.epsl.2005.09.038.
  10. ^ Squyres, S. W., et al. (2006), Two years at Meridiani Planum: Results from the Opportunity rover, Science, 313, 1403–1407, doi:10.1126/science.
  11. ^ M. Wiseman, J. C. Andrews-Hanna, R. E. Arvidson, J. F. Mustard, K. J. Zabrusky DISTRIBUTION OF HYDRATED SULFATES ACROSS ARABIA TERRA USING CRISM DATA: IMPLICATIONS FOR MARTIAN HYDROLOGY. 42nd Lunar and Planetary Science Conference (2011) 2133.pdf